Hi all,I had the below config in place so TCP 443 traffic terminated on 20.20.20.20 and unencrypted traffic was sent onto backend servers via a content rule setup to listen on TCP 80 for IP address 10.10.10.10.ssl-server 190 ssl-server 190 rsakey mys...

Hi,If i set the timeout multiplier to be 3 on a content rule so it's 48 seconds, why when i look at the 'flow-agent show fcb' information does it give me the correct inactiveTimout but then allocate a 'New FCB time' of 120 which overrides my configur...

Hi,I have a CSS 11503 with a basic content rule for TCP 10000 going to a few backend servers. I was looking into the default timeout values for flows and when testing using telnet the flow didn't terminate as expected?For example, i have no 'timeout ...

Hi,I have an IPS running inline VLAN pair mode that bridges 2 x VLANs into 1 x L2 broadcast domain allowing servers in one VLAN and gateway in another to connect to each other while forcing traffic via the IPS for screening etc.. This operates over a...

HiI'm not sure if my terminology is correct when using hairpinning but i was wondering if there is any special config needed when you try to access a content rule VIP from a server that's configured as a member of a source group on the same CSS?So sa...