We are doing a large SD-WAN deployment and we have created a device access policy only allowing SSH access from certain devices to the vty lines for all SD-WAN routers, all good.
Question is how can this be achieved on vmanage/smart/bond. There looks...
Hi, I have been asked to configure ISE to block WIn Xp machines from accessing the network. I presume this is done under postering ? Deployed a couple of ISE devices and know my way around but certainly no expert in the box, any ideas welcome-
Tim.
Hi All,
i have 7 nexus 7k's that have bug CSCus22805 where you lose the ability to copy run start. Looking at the PDF cisco have produced it looks fairly straightforward but as its a live environment and I cannot lab this out just wanted to run it pa...
Hi, i amn working for a customer on an enterprise site containing many 6509's. We have built a test environment and upgraded a chassis from sup720 running 12.2(18)SXF15 to VS-S2T-10Gb running 12.2(50)SY on the management card.I have noticed and so ha...
Hi bos,added config as descibed, was getting a lot of hits on other interfaces as well and could not decipher values anyway as I wanted to match all traffic from vlan x and port y and then set an ip prec value. In the end I connected a server to 3550...
Hi, 3550 emi, flow off on all ints. What I am trying to achieve is catching all pkts from interface f0/6 and marking them as prec2. Looking at the documentation the way forward on this per-port per-vlan, thanks in advance- config... class-map match-a...
Hi, I do not think it has worked, have posted complete config for you to look at. I have a router connected to f0/6, this is sending pings to remote switch SVI interface via this one and over a trunk to a remote switch. I am getting responseses back....
