Update: In 'Interface Settings', I did try changing the SF200-FE2 port connecting to the 10.10.10.1 router port to PVID 10 and then changing to an Access mode after applying the PVID change (in trunk mode). That did seem to allow the port to function in access mode on VLAN 10.
In 'Port to VLAN', for VLAN 1, SF200-FE1 connected to the WLC2504 Port 2 was set as UNTAGGED and SF200-FE2 connected the 10.10.10.1 router port is set as FORBIDDEN.
In 'Port to VLAN' for VLAN 10, SF200-FE1 connected to the WLC2504 Port 2 was set as TAGGED and SF200-FE2 connected the 10.10.10.1 router port is set as UNTAGGED.
With these changes it does appear that the traffic from the two WLANs are isolated and seem to be routing from the WLAN out properly.
However I still see the primary DHCP server settings not being honored for the two interface definitions. I assume there is a setting somewhere in the WLC2504 that might influence this but I haven't found it yet. I have tried adding a DHCP server override in each of the WLANs advanced settings tab to the respective DHCP server IP (172.30.3.1 and 10.10.10.1) but still seem to be getting the wrong IP addresses issued. Any ideas on what would effect this?
... View more
Hello Nathan, Unfortunately, Cisco does not support the SPA-841, and it is both end-of-sale and end-of-life. For a replacement device, you may want to take a look at the SPA303: http://www.cisco.com/en/US/prod/collateral/voicesw/ps6788/phones/ps10998/data_sheet_c78-601648.html
... View more