About rnlaberge

rnlaberge · 08-29-2012

I have a Cisco 1800 ISR router running IOS 12.4(22)T5.Clientless SSL VN is configured and working, and has three bookmarks.When logged into Clientless SSL VPN and displaying the portal page in IE-8, the bookmarks are visible and functioning as expect...

rnlaberge · 02-27-2012

I have noticed in AP1100 series documentation that loopback interfaces are to be avoided.This begs the question of what to use in their place for a source interface for snmp, logging, etc. ?Thanks.

rnlaberge · 02-13-2012

Hello,For reference I have attached the following:Network DiagramPing Results TableConfigurations for 1811 router, ap1121g root access point, ap1121g wgb.I am seeking assistance with the following problem.Referring to the attached network diagram, I ...

rnlaberge · 09-26-2010

I have an autonomous wireless AP model c1121G, and an ISR model c851w.Is there a CLI command that will show the radio's transmitter power level of these devices?regards

rnlaberge · 08-26-2010

I am confused as to the methods available to implement Dial Backup on an 1811 ISR. My router's WAN is connected to a cable modem via FA0.In reading the 1811 software configuration guide (chapter 13, page 13-5), I have viewed a table listing "Dial Bac...

rnlaberge · 09-26-2012

Upgrading the IOS image to 12.4(24)T6 appears to have eliminated the problem.

rnlaberge · 02-28-2012

Justin,That is what I am using now. But, in the spirit of best practices I was using a loopback for snmp, logging, etc., for the obvious reasons.Then I noticed the important notes concerning loopbacks, on ap1100 series image release notes, during th...

rnlaberge · 02-22-2012

Justin,Got the config back to the way it was before we went 'bare bones', minus what I mention previously. With the config stable, I have upgraded the image. It still worked on 12.3(8)JA2. As you recall Feature Navigator indicated that this was the ...

rnlaberge · 02-21-2012

Justin,So far I have reconstructed the configuration's major functions without breaking the WGBing. There are some remnants of the orginal config that will not be put back as they are either not needed or where incorrect to begin with.I'm still on t...

rnlaberge · 02-16-2012

Justin,Thanks for forcing me to do the bare-bones test.It works!!I have connectivity from a pc behind the hp-switch (see network diagram) to the internet.I can also reach devices behind the hp-switch from the root-ap, which I could not before.Now I ...

Member Since	‎07-11-2010 04:59 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	21
Total Helpful Votes Received	3

User Statistics

User Activity

IOS Clientless SSL VPN Displays differently in IE FF Chrome

Cisco AP1121G - No loopbacks allowed?

Cisco AP1121G Workgroup Bridge Problem

Is there SHOW command for wireless AP transmitter power level?

Dial Backup method to use on an 1811 ISR

IOS Clientless SSL VPN Displays differently in IE FF Chrome

Re: Cisco AP1121G - No loopbacks allowed?

Cisco AP1121G Workgroup Bridge Problem

Re: Cisco AP1121G Workgroup Bridge Problem

Re: Cisco AP1121G Workgroup Bridge Problem