Paul Smith
Level 1
Level 1
Member since ‎09-26-2012

User Statistics

  • 66 Posts
  • 1 Solutions
  • 94 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
1 Helpful Vote
1 Accepted Solution
20 Replies
10 Replies
5 Replies

User Activity

Last week a colleague and changed a customers setup to start using vlans instead of just a basic LAN. I was getting ready to put the encapsulation dot1Q command into int gig 0/1 when my colleague told me that it was already working . I checked and he...
Hi Guys, I have read the QOS section Odom's 200-125 book. It gave a good overview but I feel like I need a lot more information before I can implement some good QOS. For example I have been able to mark some https traffic using an access list and cla...
Take a look at my config. I can ping a 172 address which is great and it shows the VPN is up. What I don't understand is how? 172 is not a static route and it is not in the routing table? cdi-rtr01#ping source escape seque...
Hey guys, I have a Cisco 1920 and I am connecting to a IBM SOC Cisco ASA. I have no control over the ASA, although I have access toa read only version of the config. I am using the ISAKMP, IPSEC and tunnel interface setup, whereas they appear to be u...
Hey folks, Uptime is 5 days. Does anybody see anything in this config I should be concerned about? WAN-RTR-VPN01#sh int gig 0/1GigabitEthernet0/1 is up, line protocol is up   Hardware is CN Gigabit Ethernet, address is 2c33.115a.a7e9 (bia 2c33.115a...
Community Statistics
Member Since ‎09-26-2012 10:05 PM
Date Last Visited ‎07-31-2018 03:18 PM
Posts 66
Total Helpful Votes Received 5
Helpful Votes From