Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About m_ashok89
02-16-2018
Stats
Member since
03-31-2015
13
Posts
0
Helpful
0
Solutions
06-12-2015
02:45 AM
Thank u sir, still having little bit confuse, Could u please give with an example?
... View more
06-11-2015
12:36 AM
Dear Team, what is the purpose are using " IP VRF Forwarding " command, very confused to know about this command, whether it is necessary to use in core switch like supervisor engine 4500 series.please say the correct answer. FYI here i enclosed the running config which they are using that command. ! ! ip vrf mgmtVrf ! ! ! Regards, Ashok.M
... View more
Labels:
05-12-2015
11:11 PM
Hi Leo, I faced this issue on of my client place. right now i didn't have config file, Just i have a doubt y it was happen?
... View more
05-12-2015
11:05 PM
Hi Sayed, even i checked in my dir using "Dir Flash & Dir Boot flash" but i can't able to my new IOS image,,, when i use Shoe version commad that time in switch occupied new IOS image only and showing correct 15.2 version
... View more
05-10-2015
10:21 PM
Dear Team, In cisco switch we tried to install new ios 15.2 but already existing ios was 12.2. After complete the IOS installation i checked "Show version". In that command version is shown my new IOS 15.2, but when i gave "show flash" command i cant able to see my new ios image details. In my flash details that old IOS 12.2 image only shown. even i checked directory itself but wherever i can't find my new IOS image. but in version my new IOS image occupied. why its happen please give correct solution. Regards, Ashok.M Network Engineer
... View more
- Tags:
- #1841 #router #networking #
- #acl #snmp #mib #ciscoACLmib
- #BGP #routing #LAN #WAN #SWITCHES #ROUTERS
- #c2960 #switch #firmware
Labels:
04-21-2015
11:35 PM
what is the use of " Standby (Group id) Track "command. we totally confused to know the exact reason y we are using this command in HSRP protocol Please suggest the main reason
... View more
Labels:
Created by
m_ashok89
in VPN and AnyConnect
in VPN and AnyConnect
04-09-2015
11:05 PM
04-09-2015
11:05 PM
Dear Team, we are using Cisco ASA VPN , Some time unable to connect application via remote VPN when using mobile wifi or USB modem, but able to connect application via remote VPN when using broadband. the same scenario VPN has been connected but can't able to open sap application some time. Kindly suggest me the exact solution for it.
... View more
Labels:
04-01-2015
10:26 PM
Dear team, we are facing problem in cisco catalyst switch, actually we are using Cisco catalyst 4500e switch, Two month back we upgrade IOS from "cat4500e-ipbasek9-mz.150-2.SG" to cat4500e-ipbasek9-mz.152-2.E1.bin “since i upgrade new IOS that was running perfectly, but last two weeks back unexpectedly switch was rebooted and today also we faced the same problem. here i enclosed the tech support details. kindly check and suggest me the correct solution. Is there in any bug is there?...... How can we clarify whether the switch is ok on that IOS..... please suggest me the right IOS image for my cisco catalyst 4500e switch
... View more
Labels:
04-01-2015
02:04 AM
Dear Sir, I don't have a rights to download IOS from Cisco site....Is it possible to take IOS image without administration rights
... View more
Labels:
03-31-2015
10:22 PM
Dear Team, I was deleted my Flash memory on cisco 1841 router. After that i tried to feed new IOS image from TFTP but unable to feed the ios to router... I used these commands for in romman mode confreg 0x2142 rest
... View more
Labels:
06-11-2015
Dear Team, what is the purpose are using " IP VRF Forwarding " command,
very confused to know about ...
05-12-2015
Hi Leo, I faced this issue on of my client place. right now i didn't
have config file, Just i have a...
05-12-2015
Hi Sayed, even i checked in my dir using "Dir Flash & Dir Boot flash"
but i can't able to my new IOS...
05-10-2015
Dear Team, In cisco switch we tried to install new ios 15.2 but already
existing ios was 12.2. After...
04-21-2015
what is the use of "Standby (Group id) Track "command. we totally
confused to know the exact reason ...
Created by
m_ashok89
in VPN and AnyConnect
04-09-2015
04-09-2015
Dear Team, we are using Cisco ASA VPN , Some time unable to connect
application via remote VPN when ...
04-01-2015
Dear team, we are facing problem in cisco catalyst switch, actually we
are using Cisco catalyst 4500...
04-01-2015
Dear Sir, I don't have a rights to download IOS from Cisco site....Is it
possible to take IOS image ...
Public Statistics
| Date Registered | 03-31-2015 02:19 AM |
| Date Last Visited | 02-16-2018 02:06 AM |
| Total Messages Posted | 13 |
.jpg "Hall of Fame Master"){kind=icon}
