About Joel George

Joel George · 10-27-2015

HiI am facing a weird issue with one PRI connected to our VG .We have a CISCO3945 VG with 4 PRIs configured as MGCP to CUCM 10.5.Normal incoming calls are working fine but as soon as I enable a CallForward All to another PSTN number. Incoming calls f...

Joel George · 09-27-2015

Hi, We have tried to integrate the Cisco CUCM 10.5 with the Avaya Session Manager via SIP Trunk. We see that Cisco IP Phones are able to make voice calls fine to the Avaya phones but Cisco 8945 IP Phone registered as SIP device is not able to make Vi...

Joel George · 01-31-2015

Hi.. For a CUCM 9.1 version.. We are planning to add another Sub to the cluster over WAN.. What is the Maximum Latency permitted between publisher n subscriber as per Cisco best practice.. Really appreciate your response.. Regards Joel

Joel George · 01-14-2015

Hi, I have a H.323 gateway, the fax line is configured on one of the FXS port on the router. Fax is not working.I connected an analog phone to the same port and was able to make outbound calls but incoming calls to the number not working. I collecte...

Joel George · 07-02-2014

HiI have a Cisco 2921 router that acts as voice gateway.We have allocated DSP resources for XCODE and Conf accordingly but the 'show dspfarm all' command give the status of 2 DSP channels as 'Open' at all times.----------------------------------SLOT ...

Joel George · 10-29-2015

Hi All, Issue is resolved now, even I observed that no call setup is found for forwarded call and started comparing the settings of PRIs on CUCM. We found a mismatch in one of the Logical Partitioning Policy configured for the that particular PRI ...

Joel George · 10-28-2015

Hi Rajan, Attached is the debugs you requested, I have captured one failed call. Call Details : Calling number : 9986012965 Called number : 5899 PRI : Se0/0/0:15 Thanks ! Regards Joel

Joel George · 10-27-2015

Hi Carlo, Attached is the sh run and dsp logs. The affected PRI is e1 0/0/0, Other PRIs are working fine. Regards Joel

Joel George · 10-27-2015

Hi Rajan and Carlos, Thanks for the reply, I checked the call forwarding functionality. It is working fine, when I call this extension from another internal extension, call is forwarded properly to the external number. It is only the below call flow ...

Joel George · 10-27-2015

Hi Dennis, Looks like it was a bug on the 8945 IP Phone and TAC has released a custom firmware for the IP Phone after which it is working fine. Below is the summary I received from TAC. Problem Description:=================Video fails from 8945 acros...

Member Since	‎08-05-2011 01:52 AM
Date Last Visited	‎08-01-2018 02:27 AM
Posts	17
Total Helpful Votes Received	10

User Statistics

User Activity

Incoming call issue : Cause i = 0x80A9 - Temporary failure

Cisco to Avaya Video calls not working.

Maximum Latency between publisher n subscriber for WAN clustering

Incoming Fax not working on FXS port of H.323 router

DSP Channel always not in Free state.

Hi All,

Hi Rajan,

Hi Carlo,

Hi Rajan and Carlos,

Hi Dennis, Looks like it was