Folks, I am trying to do Leap and Eap-TLS together. How can I write a policy in ACS that would check for identity before choosing the right profile for the request. ACS 5.2 does not support Native eap-tls. I am assuming I will be using Ideni...
Folks, I have 2 access points which are far apart from each other. I have 802.1x+cckm enabled for my cisco Wireless ip phone. When I move from one AP closer to the other. The phone call disconnects. I was running a debug on the controller ...
Folks, I have a 3560 and when I try the "mls qos trust cos" command under the port channel interface it does not work. Any ideas?The command does work under the indiviual interfaces but not under the port channel interface.cat3560(config)#in...
Folks, I am testing the Universal briodge feature. When I configure two access points (root/wgb) everything works fine. When I go to the WGB and add the universal command. I get the message that since no clients are associated it will use BV...
Folks, I was able to follow the documentation and use identity sequence option on the ACS and accomish the task.I have one question, when I look at the ACS logs when EAP-TLS fails it says in the logs EAP-TLS under Authentication method b...
Justin, I upgraded the code and still no luck. WGB works fine but as soon as I put universal keyward with a mac in the end it does not associate with the root. I am running the same code as you on the root and the wgb.Here is the config ...
Folks, I have a 3560 and when I try the "mls qos trust cos" command under the port channel interface it does not work. Any ideas?The command does work under the indiviual interfaces but not under the port channel interface.cat3560(config)#in...
Scott, I would like to write a policy on my ACS 5.2 that considers the controller the request is coming from and in addition to that considers the following:2) Identity: Internal User or NAC profiler or Certificate profile3) Eap Auth...
