About geoffwynn

geoffwynn · 07-20-2022

Hello all, I have a lab machine at home which I use for all my labs however I connect to this via RDP from another Windows box. My wife is often using the main PC so logging her off every time I wish to connect to a lab is problematic. Is there a way...

geoffwynn · 02-10-2019

Hello, I have a Cisco 3725 router connected to a Cisco SF500 switch, also connected to a SF500 switch (trunked)When I try to ping 10.1.2.5 from the router, it fails. When I debug it stated:R1#debug ip packetIP packet debugging is onR1#ping 10.1.2.*Ma...

geoffwynn · 06-13-2017

Hello, I am having trouble configuring a firewall at work. It is a Cisco ASA 5520 running 8.2. I cannot paste the config as it's in a secure environment. So, basically the config is: interface gig 0/0 nameif prod ip add 192.168.1.1 255.255.255.240 s...

geoffwynn · 08-26-2014

Hello, I have a switch with some VM's hanging off of it. I want to isolate VLAN 888 which is to be used for malware, so I therefore want it isolated BUT I want it to be able to access the Internet to download malware etc. I have set-up VRF on interfa...

geoffwynn · 02-12-2019

Hello all, well, long story short, I was actually using the router in placeof a layer 3 SF500 switch (set to layer 3 mode) and after plugging it backin today and testing, it works! I think it might have been a default gatewayissue (on some other devi...

geoffwynn · 02-11-2019

Hello, sure, good idea although 10.1.2.5 is a small PC on the other side ofthe room hence the switches in the middle but good idea.

geoffwynn · 02-11-2019

Roger, will do, at home now but will inspect again in the morning. Thanksfor the help I hope to get to the bottom of this!Geoff

geoffwynn · 02-10-2019

Hello, thanks, same response from 3725 router. Here is a cut & paste:R1#pingProtocol [ip]:Target IP address: 10.1.2.5Repeat count [5]:Datagram size [100]:Timeout in seconds [2]:Extended commands [n]: ySource address or interface: 10.1.2.20Type of ser...

geoffwynn · 06-13-2017

Thanks Aditya. So, lets say I changed the interface security level to be 1 2 3 & 4. Would I need this command then? No, it would not work and the ACL's would work as expected correct?

Member Since	‎11-30-2004 02:11 PM
Date Last Visited	‎07-21-2022 09:08 AM
Posts	10

User Statistics

User Activity

Anyconnect session won't work when RDP to another Windows machine

Routing issue

Cisco ASA 5520 traffic between different zones

Cisco VRF-Lite on 3750 issues

Re: Routing issue

Re: Routing issue

Re: Routing issue

Re: Routing issue

Thanks Aditya. So, lets say I