About Namol

Namol · 08-17-2018

I did a MIB walk on a firepower device (8300 series) and I don't see the running OS version in there. Does anyone know if there is an OID for it or if it is a combination of OIDs? I found the boot image string, but ideally I'd have the running vers...

Namol · 06-15-2015

So I am trying to allow my CUCM integrated endpoints to dial to standalone devices.Using this guide, I can’t read the syntax on the regular expression:http://www.cisco.com/c/en/us/support/docs/unified-communications/telepresence-video-communication-s...

Namol · 03-30-2005

Does anyone know what kind of load is involed in Campus Manager's device polling? Is it a simple ping or is it doing a minor SNMP command to check the link state of the links between neighbors?Are there any best practices?This is using Campus 4.0 in...

Namol · 03-24-2005

For example, if I delete a device and/or a link in the layer 2 display view in Campus Manager, how do I restore it so it can be viewed again? Or does the device and the links simply reappear the next time Campus does a data collection? Using Campus...

Namol · 12-30-2004

Is there a simple way to export a configuration, preferably with the passwords intact, from CiscoWorks to a desktop? We are trying to find an easy way to be able to recover a configuration to restore via console if we lose the config on a device and...

Namol · 06-23-2015

Exactly what I needed. Thanks.

Namol · 03-31-2005

Use that command as well as always use enable secret to do a strong encryption on the enable password.

Namol · 03-30-2005

These are both good products:Cheaper but still effective:http://www.ins.com/software/netcontrol.aspor the full blown super version:http://www.ins.com/software/ipcontrol.asp

Namol · 03-29-2005

There are several possible causes for this. Make sure the config for the device isn't locked by the configuration editing programs (Config editor or NetConfig). Also make sure that Ciscoworks can get into the device using telnet or SSH, not just SN...

Namol · 03-29-2005

It will now send the entire error message as part of the body of the e-mail by default. There is no way that I have found to include the error in the subject. I have contacted Cisco TAC with several suggestions about how to improve the syslog displ...

Member Since	‎12-07-2004 11:41 AM
Date Last Visited	‎08-24-2018 02:02 AM
Posts	18
Total Helpful Votes Received	8

User Statistics

User Activity

SNMP to pull version information

Transform for VCS-C and dialing by IP

Best Practices/Load of Campus device polling

Question about Deleting devices and links in Campus Views

Configuration Export from CiscoWorks?

Exactly what I needed.

Re: How to encrypt the passwords in running-config ?

Re: IP Address Management

Re: RME - IOS upgrade error

Re: Syslog in RME 4.0