I am trying to avoid entering 200 "IP IGMP Static-Group 239.x.x.x 10.2.2.2" entries on my Cisco 7600...Are there any commands available so I can specify a multicast "subnet" to be statically joined to an interface?I would think cisco has a command si...

Im trying to load the IOS image from a Viking 128MB PC Card. I've tried Slot0 and Slot1 on the router. when the router boots I get:System Bootstrap, Version 11.1(10) [dschwart 10], RELEASE SOFTWARE (fc1)Copyright (c) 1994 by cisco Systems, Inc.C7200 ...

What will take place is I will have my 7206 pull a Dynamically assigned IP address from my Cable modem/gateway. The Cable modem will be connected @ Interface 1/0. I will then connect one PC to the 7206 @ Interface 1/6.The PC will need to pull an IP s...

I have a 7206 running c7200-kboot-mz.121-14.E.bin.. As soon as I power it on it comes up as "Router(boot)>"... So far I have gone into the router and ensured that it shows "Configuration register is 0x2102" when I do "sh ver" command.. What can I do ...

Hopefully you guys can help me.I have a 7206 that I will be connecting to My Cable Modem and will be setting up my Home Lab with..The 7206 has the Following Modules:PA-FE-FXPA-HPA-4T+The Modems Ethernet port is a 10/100 Ethernet(RJ-45). Can I use any...