Greetings,
I have a ASR1001-X with the following licenses ( see attached picture)
I would like to run the crypto command but it doesn't seem to be working.
I had booted with advipservices which I had read some where else that it would work. ...
Hi guys.
Chassis would be : ASR9010
Engine : A9K-RSP440-SE
Line Card : A9K-MOD80-TR
As seen by the first sh platform A9K-MPA-20X1GE would have its state as OK and then a few seconds afterwards it turns off and it changes its state to UNKN...
I have 2 upstreams out of the Data Center:1. To ISPs1. To other Data Centers via Layer 2 dark fiberI would like to limit the bandwidth of customers going out of 2 upstream.What would be the best way to do this? Would placing a switch in between be th...
upgraded to 6.2.3 still getting the error.
RP/0/RSP0/CPU0:ios(admin)#
RP/0/RSP0/CPU0:ios(admin)#sh platform
Thu Mar 29 04:07:35.899 UTC
Node Type State Config State
-------------------------------------...
Currently I'm running 4.3.4 which is active.
I have 5.3.4 in disk0 as well.
RP/0/RSP0/CPU0:ios(admin)#sh install active
Sat Mar 26 05:17:09.485 UTC
Secure Domain Router: Owner
Node 0/RSP0/CPU0 [RP] [SDR: Owner]
Boot Device: disk0:
Bo...
ROM: System Bootstrap, Version 12.2(17r)SX7, RELEASE SOFTWARE (fc1)BOOTLDR: Cisco IOS Software, s72033_rp Software (s72033_rp-ADVENTERPRISEK9-M), Version 15.1(2)SY9, RELEASE SOFTWARE (fc1) Would you recommened that I do; UBRL, SVI policing, SRR/WRR o...