When we look at Perfmon on the CCM for H323 it will show our GW's. 2 of them that are functional and working show:REM - nnn.nnn.58.15REM - nnn.nnn.58.16While the rest of the GW's show as IP add. without the "REM" in front. Does anyone have a clue a...
I have seen user on this forum ask about monitoring Cisco Gateways. A computer wiz wrote one for me. I use it to monitor Disconnect Cause Codes to watch the health of our gateways and build excel files for traffic tracking. You can download it for...
We run several hundreds analog lines on Vg248's. We need to block any modem traffic on these lines. Any suggestions? Cisco TAC said no way to do it. thanks
I have 432 existing 7/24 analog lines on Cat6 blades. I need to move them to 9 vg248. Cisco doesnt have a bat tool. I want to minimize the downtime, so I dont want to do this by hand-one by one. any ideas on a faster method than by hand? thanks ...
Perfmon from Publisher showed 0 calls, on Subscriber the GW H323 Perfmon should that we did have a load/or calls, on the device named REM- xxx.xxx.58.15. A control cntr restart of Services on Subscriber resulted in the REM going away and just the...
Michael: see the following article:http://www.cisco.com/warp/public/cc/pd/tlhw/prodlit/7910_ds.htmDepending on the model 7910G and 7910G+SW you either get a 1 port 10T for the phone or a 2 port 10T for phone and a 100T to plug your computer into and ...
Copied from email from TAC when I asked the very same question:********************************************************************************MarcSo, its ip phone to ip phone with no route-pattern involved.This is doable ..but has a lengthy process ...
dcharlier: are you using MGCP or H323? We have a near same setup, except we run a T1 tie line between our Cisco and Ericsson BC09 and use H323. Below is the dial-peer on the VG200:dial-peer voice 100 pots preference 3 destination-pattern [1-7]... p...