Is it possible to use processing instruction in devices templates that are used by NSO compliance reports?I am looking to validate configurations based on the platform model normally in a service template I would use: <?set-root-node {/devices/device...
Hi,
I am having some challenges when implementing config templates based on device version using config-template only.
My solution is aiming to use the platform version from the devices provided by the NED based on the version nr a config template ...
Hi,
I have some question which I am struggling with, I have to read the device NED type from the device module. Almost all NEDs returns with position 0 from the keys the correct NED type except IOS-XR NED the position of the NED type is not 0 but 3...
You can do that by modifying the ncs.conf file:
Under the <CLI> section in the ncs.conf file, you can add <style>c</style>
This will change the CLI behavior to Cisco style as default.
<cli>
<style>c</style>
Thank you very much for pointing that out, after reading the man page I have to change the logic to the following:
<?if {string-compare(/version, 'saos-06-14-00-0434') <=0}?>
The result worked exactly as I wanted...
