Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I'm facing problem with ipv4 address. I have configured a list of address on bgp but few ip pool not showing mask, even though I have configure.
Below are the output.
network 192.232.131.0 mask 255.255.255.0network 192.245.196.0 mask 255...
Dear All, I'm facing problem with latency to point to point IP configured on cisco L3 switch. switch details as follows.Model: WS-C3750X-24Flash:c3750e-universalk9-mz.152-2.E.bin UPCOUNTRY-L3#sh int g 1/0/10GigabitEthernet1/0/10 is up,...
Hello, I'm facing problem with one SFP port, which showing port state fault. To troubleshoot it I have shutdown the port and un shutdown the port still the same. And how to recover that port to normal state with restarting the switch. Regar...
Hello,
I have reverted configuration. But how to make less attractive for return traffic on ISP1, request you to provide the sample configuration for same.
Thanks in advance,
Hello Again,
To brief my requirement is we have two ISPs assume that ISP1 and ISP2. Were else I would like to block a host coming from ISP1 but it should able to reach from ISP2.
Kindly help me out from this.
Thanks in advance.
Hello,
Thanks for your reply, I have one more problem. How to block a IP address on BGP.
Note: we have two ISP's we would like to block on isp1.
Regards,
P.Naveen.
