Dear All
Today i have installed a new 1921 Cisco Router, i wanted to connect my isp modem to one of the gigabit port at the router, and then my pc to the other gigabit port.
i have configured my pc ip statically to be in the same range of the gig...
hey guys i can't configure my cisco 1900 series model 1921 router, i know the basics but am new for this someone help me to configure step by step THANKS.
i did that, but it don't work
but i plug my pc to switch and i give the pc ip 192.168.1.3 255.255.255.0 getaway 192.168.1.1 and dns server 213.55.96.166 it works, i think the switch needs dns ip and getaway ip
Thanks
Very very Thanks sir for your time and sharing ideas.
Everything is working now on my pc.
but i want to connected to switch, switch model- "sf300-48pp 48 port managed switch"
the switch needs configuration?
Thanks sir.
yes i did save the config "copy run start" or "wr mem" but when the power goes and come the interface wont start itsel unti i do "no shut" command to each interface.
here "sh ver"
Cisco IOS Software, C1900 Software (C1900-UNIVERSALK9-M), Version 15...
!!!interface Embedded-Service-Engine0/0 no ip address shutdown!interface GigabitEthernet0/0 ip address 10.141.54.104 255.255.240.0 ip nat outside ip virtual-reassembly in duplex auto speed auto!interface GigabitEthernet0/1 ip address 192.168.1.1 255....
