Hi everyone, I have a weird issue going on in our data center. I recently upgraded the network module on a cisco switch from 4|1gb ports to 2|1 GB 2|10Gb. The 2|1gb are shut. I did create an etherchannel/portchannel to the aggregation cores switc...
Dear everyone,
Cisco 3850 48ports non-poe Version 03.03.00SE
configured span port and I see an amber light. I see the interface is capturing the traffic. I am monitoring 2 interfaces in one session, but I do not see the traffic going out to my ...
Can I add the core switch to be NTP server for the rest of the switches 3850.
What is best practice: create one of the switches to serve as the NTP server or to point every single switch to the public external NTP server?
thanks
Dear all,
I am in the process of replacing my two core aggregation switches (3750 1gb 12 ports) with 3850s 16-10GB ports.
Currently, I am not stacking both switches (3750) but uplinks them each other via 2 etherchannels. In addition, I am have...
Dear everyone, this is my first posting on the forum, so please excuse me if this question was already ask. I need to upgrade my core backbones switches from 1gb to 10gb
Which of these two options will you advise and why: Our goal is to uplink a...
Just want to let everyone know that after removing the LACP etherchannel, the issue with vmware hosts disconnecting continued. I did rebuild the etherchannels on LACP ( this is what vmware recommends anyway).
Reza,
when you said "Make sure to negate it on both interfaces first if not you will see an error" you imply to do the command on both interfaces on the same switch (6/1/1 and 6/1/2), but no changes are needed at the core/aggregation switch?
than...
Marce, the switch does not show any log errors. The ports lights stay solid green (no orange or on/off).
Per Infrastructure Engineers, within vmware, one or two hosts only out 20 or so goes green and yellow (no available) Then it will become avai...