Since the upgrade, CiscoView is no longer visible in the CS>Soiftware Update>Device Updates Window! Application is still registred, but when trying to upgrade a dfm, error message "no registred with PSU" appears.Thanks for any advises!
Hi there!After upgrading to LMS 2.6, I'm no longer able to configure a LAN port on a switch with CiscoView. All I get is an Error Message "Error on page", the changes are not acdcepted. I already tried with different IE Versions as well as different ...
Hi there!I'm a little bit confused about the way i could integrate ITEM into CW. Does anybody has an advise or a document how to install ITEM alongside an existing LMS installation. In the official installation procedure, it is stated that all existi...
Hi Guys!Does anybody has an idea how to resolve the follwing issue:Some providers offer a special service called "partial reroute" which allows for example to reroute a single phone number out of a range of numbers. This service can be activated by p...
Hi NathalieRegarding the problem you are reporting, I had a similar case some month ago. For further password changes I solved the problem in the way, that I activated the password encryption service on all devices and sent unencrypted passwords with...
Thank you for the reply. I ordered CWITEM-2.0-ADD-K9 and was sure that this would integrate into CiscoWorks. Can't find any document which describes how to "integrate" this in CW. Any suggestions?Thanks and regardsAndy