About maxwell.n

maxwell.n · 10-09-2018

Hi there I need to shift the interface used for the VPC peer between 2 of my Nexus Switches to a different interface. I plan to bind a different IP address on the new VPC peer interface on both switches before the change and then during the outage ...

maxwell.n · 10-09-2018

Hi There Are you able to add interfaces of varying speeds into a Port-Channel? Specifically adding a 10Gb and a 40Gb interface into the same Port-Channel on a Nexus 9200 series switch? I know that technically all interfaces in a port-channel shou...

maxwell.n · 08-19-2019

Hi There. Did you ever resolve this issue? I have a similar problem. ThanksNeal

maxwell.n · 10-10-2018

Hi ADP Thank you very much for your response. This is very helpful information. Appreciate it! Regards Neal

maxwell.n · 10-09-2018

Yes. This is a good idea. Thank you!

maxwell.n · 10-09-2018

Thank you. I expected as much. I was just wondering whether the 40Gb interfaces would accept the port-channel config in a shutdown state, so that I could prepare the config beforehand, but better to be safe and not even attempt this. Thanks again.

Member Since	‎06-19-2018 04:20 PM
Date Last Visited	‎08-21-2019 12:28 AM
Posts	6

User Statistics

User Activity

Changing a VPC peer address on a Cisco Nexus? What are the implications in terms of an outage?

10Gb and 40Gb interface in the same Port-Channel on a Nexus

Re: Nexus 9K Span Port - Output Discards

Re: Changing a VPC peer address on a Cisco Nexus? What are the implications in terms of an outage?

Re: 10Gb and 40Gb interface in the same Port-Channel on a Nexus

Re: 10Gb and 40Gb interface in the same Port-Channel on a Nexus