About leonardo_split

leonardo_split · 01-17-2012

Hi all,I'm looking for help in configuring CISCO environment.... usually rookie question :-)We have two routers ( 2600 series, IOS 12.0(7)T ), E1 connected via PRI 2CE1U interface on both sides. The routers are equipped with WIC-2T serial interface ...

leonardo_split · 01-23-2012

Richard,I have no experience in configuring CISCO equipement, so I'll accept all your opinions as God's voice :-)I found this:http://www.cisco.com/en/US/products/sw/iosswrel/ps5014/prod_release_note09186a00800810a3.htmland it says that it is possible...

leonardo_split · 01-22-2012

Hi acampbell,thanks for reply.I was looking on official page and found that it is possible to find appropriate IOS for this amount of memory. Even Enterprise feature set can be find with 8/32M. c2600-js-mz.120-8Where did I get wrong?Regards,Leo

leonardo_split · 01-21-2012

Hi,here it is.myrouter#sh verCisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-I-M), Version 12.0(7)T, RELEASE SOFTWARE (fc2)Copyright (c) 1986-1999 by cisco Systems, Inc.Compiled Tue 07-Dec-99 02:12 by phanguyeImage text-b...

leonardo_split · 01-19-2012

Hi,strange, but I can't enter stun peer-name command in global configuration mode on my router. This has to be basic command if I want to do anything with STUN protocol. Am I right? Did I put the router in kind of mode that has limited features for ...

leonardo_split · 01-18-2012

Thanks.I'll try. I have already connected and configured Serial WAN interface, your example didn't predict that... anyway, I'll post the result.Thanks again.

Member Since	‎01-04-2012 01:14 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	6

User Statistics

User Activity

Serial tunneling

Serial tunneling

Serial tunneling

Serial tunneling

Re: Serial tunneling

Serial tunneling