Hi, i am trying to configure cisco nexus 5548UP with GLC-LH-SMD 1g sfps after changing the speed of the port the port came up and reason shows none. but there is no communication between the ports. do i have to do any other configuration, also i saw ...
Hi, i am trying to connect cisco sfp GLC-LH-SMD to cisco nexus n55 series switch. but it was showing spf validation failed and after changing the switch port speed to 1000 the port came UP but the link was not active and reason shows none. and tried...
Hi, I have a cisco2911 router with IOS : Version 15.2(4)M6a and would like to know does this router supports IPsec #sh ver >> Cisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version 15.2(4)M6a, RELEASE SOFTWARE (fc1) Technical Support...
Hi, we have CUCM configured with gateway cisco 2911 and anlog POT to FXO. and planning to upgrade to SIP trunk ( checking from local ISP and cloud as well). so do i need extra T1 and E1 interface card or can i use the gig0/0 interface on the router....
Hi jon Thank you very much for your supporti disabled the caller id . now two ring reduced to one is there any way to avoid the first ring on this analog line thanks
