Hello Christopher,Do you configured a policy rule for this traffic? ( VPN -> Email )? Do you use any type of split tunneling?Public IP is pointed at OUTSIDE(DMZ) or EMAIL zone? If you can share a simples network diagram and packet tracert with this t...
Hello, The AnyConnect is the default gateway for this connection? Please, send a nat configuration for this scenario. I think a simple ""no nat"" can solve this issue if the subnets don't overlap in the network path. Regards,Fernando
Hello,This is a VM server?Please see status interface connected to the host and send me too.(show interface status)Check if the gateway of this server have a arp table to server's IP.Can you draft a simple topology with all elements in the path?
Hello, I think the command "channel-group protocol lacp" in switch side make this issue. You can try to remove this command and specify in router side "channel-group 1 mode active/passive" or configure "mode on" in boths sides(SW/RT).