wr3500
Level 1
Level 1
Member since ‎10-24-2004
‎08-18-2017

User Statistics

  • 19 Posts
  • 0 Solutions
  • 14 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

Yeah I know this has been covered already. I have the following issue. I have a two segments on the firewall, behind these 2 segments I have two L3 devices. VL622 is the higher security interface at 80 while VL621 is lower at 70.I have a static:stati...
I am looking at upgrading a 515E to 7.2(X) release but I am wondering about the memory requirements. The PIX in question has 64MB Ram/16MB Flash, UR and FO licensing. I keep seeing in the memory requirements that it needs to be a minimum of 128MB Ram...
I currently have PIX 515 setup running ver 6.3(5) in an active/standby configuration. I was wondering if it is possible to upgrade these to 7.0 and run them in an active/active configuration.
I have an issue where I need to bring a network into our network but because of that fact I can't route 172.x.x.x addresses through our provider (British Telecom Private Network)I need to figure out a way to nat a zone to another. The group is coming...
I know alot of these configs have been covered here and have read a few today. Here is my dilemna. We have a VPN concentrator in our GO in Florida. We are setting up a remote contract site in another state. The customer is allowing us to place our PI...
Community Statistics
Member Since ‎10-24-2004 11:43 AM
Date Last Visited ‎08-18-2017 03:53 AM
Posts 19
Helpful Votes Given To