I am looking for advise. I have a switch with C3750-IPBASEK9-M, version 15.0(2)SE software installed. According to release notes in below link; https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750x_3560x/software/release/15-0_2_se/configuration/guide/3750x_cg/swiprout.html It says under OSPF Routed Access: Note OSPF for Routed Access supports only one OSPFv2 and one OSPFv3 instance with a combined total of 200 dynamically learned routes. The IP Base image provides OSPF for routed access. However, these restrictions are not enforced in this release. As it says these restrictions are not enforced in this release, can we configure multiple OSPFv2 and OSPFv3 instances as well as does it support more than 200 dynamically learned routes? Is there any risks involved?
... View more
I am currently testing with IE-5000 and IE-2000 switches. I have booted them using the SD cards. I tried below command in all the switches; snmp-server location in Abcd Efgh I don't face any issue in IE-2000s. But with IE-5000 I can configure this command. When I copy the running-configuration to startup-configuration I can see this appear in both configurations. But after I reload the switch it is not appearing in the running-configuration. It is appearing only in the startup-configuration. I don't face any issue with other snmp-server commands like community definitions, enabling traps etc. When I sync sdflash: flash: and reload the switch it has gone even from startup-configuration. I tried this with 2 IE-5000 switches and I faced the issue in both the switches. I don't face any issue with IE-2000s. Any advice would be highly appreciated.
... View more