Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I would like to ask should the OSPF process ID the same for all the routers within a single area? I have seen some examples in cisco website where each router within area 0 uses a different OSPF process ID. Can anyone clarify this for me? Thanks.A...
Hi,Recently I have to install a PIX with three interface to protect a MS Exchange System. A front end exchange 2003 server will be placed in the DMZ. A back end Exchange 2003 together with the Domain Controller, Global Catalog Server will be placed i...
Hi,In PIX access list, what is the difference between the two? If I what to permit normal ftp access to my internal server, do I need to open both? or just ftp? What is ftp-data for then?Thanks.
Hi,Can any one tell me if there is a topology change in my LAN network and ethernet ip addresses of two LAN routers are going to swap over, how long will it take for the arp tables of the two routers to update themselves? Since the default arp timeou...
What is the difference among the three in frame-relay configuration? How to properly configure the three? And what are the default values if they are not manually configured? Thanks.
Hi,Just more information:1) Other Exchange servers on remote sites are Exchange 5.52) There will be three servers in the internal netowrk: a back end Exchange 2003 server, and two Window 2003 Domain ControllersThanks Andrew
Basically, my LAN has two WAN routers, one (router A)with an ethernet address 192.168.0.1 and the other (router B) has 192.168.0.2. What I am trying to do is to put 192.168.0.2 in router A and 192.168.0.1 in router B. All the PCs in the LAN have thei...
Thanks for the links.Say if I have a FR with 128K CIR and 64 EIR given by the telco, then what values of "cir" and "mincir" should I use? What would be the effect if i leave them as default? Is it really important to set these values correctly?Thanks
Hi Skarundi,What I mean is that whatever I typed in (such as enable), it just returned the unknown_4# and I couldn't continue to change the password. Thanks.
