I have a very strange issue that I can't explain that I was hoping for fresh ideas.
Scenario - We have 100 spokes, all have 881's with dual DMVPN tunnels to two different Data Centers. The DMVPN hub routers site behind ASA's.
Issue - One of the spo...
I have two data centers that I'm setting up. Two ELINE Point-to-point (Layer 2) circuits were ordered for the DCI between them. What routing protocol should I use across these WAN circuits...? I was originally planning on using EIGRP to keep the rout...
I've run across an issue with a new 5672UP switch and GLC-T modules that I was hoping someone had an answer for. When I insert the GLC-T modules into the 5672UP and plug in another device (via CAT 6 Ethernet), the other device (an ASA in this example...
I'm setting up DMVPN and want to send all traffic via the hub (RFC1918 & internet). I want to do this so that I can do content filtering in one central location as opposed to 60+. I must be missing something because when i ping from R1 (192.168.15.1)...
Does anyone know the meaning or why a route is marked hidden? I've searched for some documentation on this but can't find any. I'm assuming that since 10.2.12.20 (loopback that eBGP is peering over) and 10.11.2.2 are the same device, it's choosing IG...
*UPDATE*
As expected after the ISP replaced the modem the issue is now resolved. This is concerning because somehow the 'faulty' modem was able to differentiate between IPsec encrypted ICMP packets and other IPsec encrypted traffic. Big brother or ...
Mohammed,
The output of 'show ip route x.x.x.x' and 'show ip cef x.x.x.x' are what would be expected (the tunnel interface and hub tunnel IP.) The output of 'show ip nhrp brief' shows the correct mapping. Regarding the traceroute, keep in mind that...
Oh ok. I've been looking all over for more info on the 2100's but my guess is that FTD is missing a lot of features vs the ASA code because there isn't a ton of reviews or information on them yet. My understanding is that you can buy a 2100 and inst...
nathanielscriven I'm interested in learning more from your experience here. So did you purchase a 2100 series with FTD but because of lack of feature set you installed the ASA code on the 2100?
