Hi All, Please could someone assist with the following ? I have been provided with a set up for a network where I manage where we have 2 sites with a subnet on each 10.201.0.0/16 and 10.202.0.0/16, connected with a P2P link. The network at the moment...
Hi All, I have just purchased a ISR4331/K9 with a SM-X-ES3-24-P. I am getting the below error message:*May 22 13:45:55.331: %SPA_OIR-3-EVENT_TIMEOUT: subslot 1/0: Timeout waiting for SPA OIR event-Traceback= 1#00996a21ae914aca4b637c04ca379136 :7F8EED...
Hi, I have an ASA 5525-X running software version 9.3.4.5 (5) and ASDM 7.5. I have no whad to renew my URL filtering etc and found out I had to upgrade to firewpower, which I have now done. I have recieved a PAK key which I have been able to associat...
Hi, I need to upgrade my the software on my ASA5525 to firepower - I have purchased this licence but I am not able to upgrade using my current version of ADSM as it does not have the firewpower module. Is there a way to do this withou having get a co...
Hi,
I currently have BT Home Hub with a DMZ and port forwarding configured. Unfortunately, the home hub does not have the capability to configure rules based on source/destination IP addresses so I need something that I can configure ACLs on but, s...
Hi Gisueppe, Thanks so each firewall would use the physical interface of the local gateway router so in this case 80.169.68.209, then 80.169.68.210 then only present the virtual gateway to the clients ? The the floating static to the physical interfa...
Hi Giuseppe, This will be utilising an existing layer 2 link. Thank you for the confirmation re the static route, I thought this would be necessary as traffic should be going out of the local router when both routers are available, then if one fails,...
Hi Reza, Thanks for your help, please see the attache diagram. So the /28 subnet was provided by the ISP for the VRRP groups. As each router is connected to a seperate backbone routers, we have a different WAN subnet for our public IPs which are the ...
Thank you for your help; unfortunately, I am still gettting the same issue - I have even replaced the switch module and am having the same issue. Do you think it could be an IOS issue ?
