About Adarsh_Chauhan

Adarsh_Chauhan · 06-28-2019

Hi Team, I have tried to go through the following links but i am unable to join the pieces together.I have user with system level privilege. I have downloaded the xml schema however i cant understand how do i use them in my python script and make OCI...

Adarsh_Chauhan · 03-28-2019

for example:i have 5 sites: A,B,C,D, E andeach has local gateway: GA, GB, GC,GD, GE. if you have to route calls through local gateway for each site your configuration will look like this. Route pattern 1: 9.XXXXXXXXXX ----> Routelist1---> RouteGroup-...

Adarsh_Chauhan · 03-28-2019

if during the call you can run the each command thrice in an interval of 10-15 seconds.show call active voice briefshow voip rtp connectionsRegards,Adarsh Chauhan

Adarsh_Chauhan · 03-28-2019

Hi, You should have option ping enabled on cucm for the trunks as well as on the dial-peers.if one dial-peer fails it should route it through another dial-peer.if trunk between cucm and gateway fails depending on which layer it will mark the trunk do...

Adarsh_Chauhan · 03-28-2019

Hi, If a route pattern has route list which has standard local route group then Device pool comes into the picture. Regards,Adarsh ChauhanPlease mark helpful or correct.

Adarsh_Chauhan · 03-28-2019

Does it work without sip-profiles 100can you remove sip-profile 100 from global configuration and isolate if it works without that.Regards,Adarsh ChauhanPlease mark correct or helpful

Member Since	‎07-02-2018 02:31 AM
Date Last Visited	‎01-06-2020 09:21 PM
Posts	34
Total Helpful Votes Received	45

User Statistics

User Activity

Broadworks OCIP calls

Re: device pool

Re: CUBE to SP - Call not being forwarded from CUBE to SP

Re: Routing logic on CUCM route list

Re: device pool

Re: CUBE to SP - Call not being forwarded from CUBE to SP