Hi,
I have a working SIP Trunk between Yeastar TG100 GSM Gateway and Cisco CUCM as follow :
TG100 ip address = 172.68.9.41
Cisco CUCM ip address = 172.68.9.31
TG100 -- {sip trunk} -- Cisco CUCM -- Cisco VoIP Phones (extension 10xxx)
I can suc...
Hi,
I've created SIP Trunk between Yeastar TG-100 GSM Gateway and Cisco CUCM.
TG-100 ip address is = 172.68.9.41
Cisco CUCM ip address is = 172.68.9.31 (extension number is 10xxx)
In TG-800, i create two call route, one for Cisco to GSM and ot...
Ok, i have config the DTMF on CUCM to "No Preference" and do reset, but still same result.
Outsite calls can reach CUCM because i create route for incoming calls to be forwarded to CUCM via the SIP Trunk, also there is a parameter at TG100 where i ...
I finally solved it.
So, after i put the CSS as recommended by Nashaatmusa, i also create Route List, Route Group for this SIP Trunk and edit the Trunk Security Profile as attachment.
I do reset at the Trunk, SIP Trunk Security Profile, and suddenly ...
Ok, so i put the CSS in place, apply config. But still same result, i got Cisco CUCM tone but no other response until call ended.
I attached the Cisco CUCM trunk config i modified, and also below is the log from TG-100, maybe there are something in t...
yes, i assigned partition to the voip phones.
do you mean that i had to config CSS (Calling Search Space) at the Cisco CUCM Trunk ?
(as attachment)
Thanks