About Mbounda

Mbounda · 05-30-2023

Dear,I would like to install an AireOs image (8.10.162) on my Cisco WLC from CIMC vKVM in using a ".AES" file type as downloaded from Cisco Software Center.I tried to map this file (.aes) as a virtual device/virtual media through the vKVM of CIMC int...

Mbounda · 11-11-2020

Dear,I just bought a used Router 2811 which is protected by an unknown password.I would like to reset the password in order to be able of accessing the prvildge mode and config mode.I first tried to remove the flashcompact when booting in other to ac...

Mbounda · 06-08-2020

Dear,I am facing a problem about the output of the show tech command. Indeed, when I try to display it on the screen, it's too long so impossible to handle it.Then, I decided to send the output into a file on a windows server like this : R1# sh tech ...

Mbounda · 05-30-2023

I would like to add that when I try to boot the WLC server from vKVM in using ".iso" file as virtual media/virtual device, following the process "F6" & choose "vKVM DVD", the system stuck on the bootloading process with the display of "Cisco Boot loa...

Mbounda · 11-11-2020

Dear Georg, thank you for your reply.But I already saw and tried those two methods before without any success.The first method, I can't apply it because I don't have access to the Router executive mode (Password prompted) and I can't also access to t...

Mbounda · 06-09-2020

Dear,Thank you ! I didn't think about the way to get these data in using the PUTTY settings. I used it and I got what I was looking for even though I don't know exactly why my command didn't succed.

Mbounda · 06-08-2020

Hi,I am also facing the same problem with the long output of the sh tech command.Do you think that it's also possible to send the output file into the windows-server from which I am using Putty ? Because I am trying to get set the explorer address 10...

Member Since	‎07-05-2018 05:02 AM
Date Last Visited	‎12-13-2023 12:23 AM
Posts	7

User Statistics

User Activity

WLC Image to install from CIMC KVM with AireOs file type ".aes"

Router 2811 access rommon

how to send an output of cisco command into a text file on a windows server

Re: WLC Image to install from CIMC KVM with AireOs file type ".ae

Re: Router 2811 access rommon

Re: how to send an output of cisco command into a text file on a windows server

Re: redirect results from sh command to text file