Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning,
I'm trying to configure an ASA cisco in my network.
I have a Juniper SRX100 router, configured as a bridge, then, directly connected I have the Cisco ASA and connected to the inside interface my switch Catalyst.
Connected to the ...
Good afternoon Georg,
I have tried with that but still is not working.
If I do "show nat" I can see that there are only translates in one direction (inside ---> outside):
Auto NAT Policies (Section 2)1 (inside) to (outside) source static obj-be...
Good morning Georg,
Thanks for your answer, I have the access rules configured and I think the problem is in the nat because if I do:
F1S-Mu# show natAuto NAT Policies (Section 2)1 (inside) to (outside) source static obj-beta obj-beta-exttransla...
Hi,
It is because I must be able to access to them from different locations (I have a NAS, a Remote Control server...) so it is very important to have a specific public IP in order to be able to connect to each server.
Thanks,
Hi Georg,
I don't have DMZ, I am just trying to configure a NAT to translate the servers public IPs to the private IPs in my LAN.
I attach a drawing of my topology.
Thanks!
