I upgrade to a Flash 32mbs memory stick, as I reboot the 2600 Cisco router, it appear in the ROMMON mode, nonetheless, I followed some wrong procedure by changing components on the ROMMON command line illustrated below, however now the router...
I am trying to config a 2620 Cisco router to perform subintreface (F0/0.1) for Vlan Trunk Protocol, however when I try to configure the encapsulation dot1q, I continue to receive error massage with ^ symbol below the 'c' See below, the platform ...
Having touble pinging a TFTP Server Connect a PC using the console port to a router for the perpose of UPLOADING IOS to a TFTP Server on my PC. I connect the PC Host to a router E0/0, I config the PC with a (static IP 192.168.1.2 subnet mask 255.255...
Within the hyper terminal, I set the port setting to 9600 bit, however I can’t key anything within the console command line. Any suggestion on how to get around this problem and change baud rate, if not through the hyper terminal?Yes Nik, I Cha...
I config the ip route as you inform me but the encap dot1q still didnt work.Router(config)#ip route ? A.B.C.D Destination prefix profile Enable IP routing table profile static Allow static routes vrf Configure static route for a VPN R...
I believe you are correct, I followed your link and inserted the IOS #c2600-i-mz.123-26.bin, the outcome was c2600-i-mz.123-26.bin 12.3(26) 2620-2621 IP,Therefore I believe I need an IOS the has the feature of IP PLUS. Is there any way you c...
