I am working with IR1101 running ir1101-universalk9.17.06.01.SPA.bin with P-LTEAP18-GL LTE module. I am trying to bring the Cell interface up and have been running into some issues. Relevant configuration here controller Cellular 0/1/0lte sim data-...
While attempting to perform a bundle install upgrade from ir800-universalk9-bundle.SPA.159-3.M1.bin to ir800-universalk9-bundle.SPA.159-3.M2.bin, one of my modems failed and is now in ROMMON-1. I have tried the rommon recovery procedure as described...
Turns out I had the wrong APN name. my original configuration works. Only other change i did was switch from 3G to 4G. Thanks for taking a look! conf t
int cell 0/1/0
shut
exit
cell 0/1/0 lte tech lte
conf t
int cell 0/1/0
no shut
I tried recreating the profile, but did not see any change cellular 0/1/0 lte profile create 8 <apn> none ipv4v6
controller Cellular 0/1/0
no lte sim data-profile 7 attach-profile 7 slot 0
lte sim data-profile 8 attach-profile 8 slot 0
Interface shows up, Profile remains inactive. Cellular0/1/0 unassigned YES NVRAM up upCellular0/1/0 is up (spoofing), line protocol is up (spoofing)
Hardware is LTE Advanced Pro CAT-18 pluggable-Global Multimode LT...
A number of the configuration parameters are not available under Cellular interface router(config)#interface Cellular0/1/0
router(config-if)#no dialer in-band
router(config-if)#dialer pool-member 1
%Configure a "dialer in-band", or "dialer pool" firs...
The chat-script lte took, but dialer string lte did not. I swapped out the 255.255.255.255 with 0.0.0.0 in dialer watch-list 1. Slightly different output from dialer. router(config)#interface Cellular0/1/0
router(config-if)#dialer ?
callback-secu...
