S Kumar
Level 1
Level 1
Member since ‎12-01-2010
Online

User Statistics

  • 51 Posts
  • 2 Solutions
  • 0 Helpful votes Given
  • 40 Helpful votes Received
Recent Badges
20 Replies
1 Accepted Solution
 30 Helpful Vote
10 Helpful Vote
1 Helpful Vote
10 Replies
5 Replies

User Activity

I have ASA5506-X running 9.16.4Gi1/1 will be used as  outside interfaceGi1/2 & Gi1/3 will be  member of bridge group 1.interface BVI1 will be used as inside interface.Does the following interface config looks ok?Do I need to configure security level ...
I want to NAT single inside IP to multiple outbound IP's based up on the destination subnet. For example : My appserver should be natted to 10.10.1.10 for packets tx/rx toward customer1My appserver should be natted to 10.10.2.10 for packets tx/rx tow...
One of our customers wants to connect to us using a private link.Customer wants to have all the communications encrypted over this link. Customer had suggested GRE tunnel with IPSEC.MPLS provider will deliver a RJ45 link to us as well as towards our ...
I have Cisco ASA5506 running on 9.9. We have multiple L2L VPN tunnels going on. The PCI scan is failing because UDP port 500 is open for anyone. Few of the posts are talking about using the control-plane ACL. I have never used it, is the following co...
Hello, We are using ASA5506-X (9.9.2). We have few policy based IKEv1 tunnels and one route based IKEv2 tunnel. I received a call this morning that L2L VPN tunnel with one of our customer is down. I looked at the debug and found following entry in th...
Community Statistics
Member Since ‎12-01-2010 02:34 PM
Date Last Visited ‎03-28-2024 01:16 PM
Posts 51
Total Helpful Votes Received 40
Helpful Votes From