About herve.durand

herve.durand · 06-23-2008

Hi everyone,I've been trying to deploy a L2/L3 switched based infrastructure that will provide the attached IP multicast fault-tolerant environment.I have sources on one site multicasting a Video stream over dual Eth/IP ports. Each of these ports is ...

herve.durand · 06-08-2007

Hi,3825 with 2 x WIC-1B-S/T-V3 in Turkey. Not able to make ISDN calls from London. Calls answered, PPP authentication Ok but calls then immediately dropped. Router running IOS 12.3(14)T7 SP Services.BRI i/f configuration:interface BRI0/1/0 no ip addr...

herve.durand · 06-24-2008

Ok, so anycast RP would be the solution? I'll give that a try.Thanks.

herve.durand · 06-11-2007

Well, even though the PPP debug showed that authentication succeeded, remving CHAP config (including username) and putting it back appears to have solved the problem.Thanks for the hint.

herve.durand · 06-08-2007

With your 1st access-list you are rate-limiting traffic for hosts 192.168.5.1 and 192.168.16.6 only.With the 2nd access-list, you are rate-limiting everything except traffic for hosts 172.16.x.x and 192.168.y.xI would recommend using a more specific ...

herve.durand · 06-08-2007

Q.931 debug:Jun 8 18:33:13.869 GMT+3: ISDN BR0/1/0 Q931: RX <- SETUP pd = 8 callref = 0x01 Bearer Capability i = 0x8890 Standard = CCITT Transfer Capability = Unrestricted Digital Transfer Mode = ...

Member Since	‎04-14-2005 12:30 AM
Date Last Visited	‎02-22-2021 10:25 PM
Posts	6
Total Helpful Votes Received	4

User Statistics

User Activity

IP multicast routing redundancy

ISDN BRI issue on Cisco 3825

Re: IP multicast routing redundancy

Re: ISDN BRI issue on Cisco 3825

Re: rate limit

Re: ISDN BRI issue on Cisco 3825