About meumeuh_toxin

meumeuh_toxin · 07-28-2005

Hi,I have a pb with my system: when a user calls a busy user, he does not get the busy tone. The phone shows "call proceed" but caller does not know the other one is busy...That is not happening to all my phones...that what i found strange...Any idea...

meumeuh_toxin · 07-05-2005

Hi,Anyone knows if it's possible to downgrade a call manager from version 4.1 to 3.3.4 ?Any advice? Document?thanks.

meumeuh_toxin · 06-17-2005

Hi,One question about how to call a remote site that has failed and is SRST.Normally, when my SITE1 (1XXX) calls SITE2 (2XXX), the call goes through the WAN as the CCM knows the IPphone DN because they are registered and therefore in the routing tabl...

meumeuh_toxin · 06-15-2005

Hi all,In the documentation about the Line/device approach for routing and restrictions, Cisco says that caveats are for Call Forward that the CSS used is really "none" if "none" is configured in the CallFwdAll box.Therefore, I would think that if i ...

meumeuh_toxin · 06-14-2005

Hi,I will use the NL dial plan provided by Cisco.I would like to make a filter for 08 and 09 numbers.What are the 08 and 09 numbers in the Cisco list ?When I look at the choice for the NL filer, I have Freephone, paging, premium, service...I know 08 ...

meumeuh_toxin · 06-15-2005

no, the destination pattern is meant to be your IP phone.Now, if your router receives a call with destination number 0198765432, and your IP phone number is 432 , then you should remove the first 7 digits.this can be done by using a translation rule ...

meumeuh_toxin · 06-15-2005

Why do you use the session protocol SIPv2 ?Anyway, the checklist is, i think, the following:- dial peer pots- dial peer voip- Gw definition on the CCM (device-> Gateway)Now, you should be carefull on what you receive from your provider.You are using ...

meumeuh_toxin · 06-14-2005

Normally on your gateway, you need to configure at least 2 dial peers:dial peer voice X POTS anddial peer voice Y voipIn the second one, you should have a command like :destination-pattern <@IP CCM> good luckcheck out: http://www.cisco.com/en/US/part...

meumeuh_toxin · 06-14-2005

Thanks very much for your help.

meumeuh_toxin · 06-10-2005

Thank you, Your explanation made me understood something about my problem :-)thanks for all your answers.

Member Since	‎04-21-2005 12:25 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	27

User Statistics

User Activity

no busy tone with 4.1(2)

downgrade from CCM 4.1 to CCM 3.3(4)

overflow solution when remote site is SRST

Call Forward CSS

Netherlands Dial plan

Re: Can not receive calls from PSTN through CCME

Re: Can not receive calls from PSTN through CCME

Re: Can not receive calls from PSTN through CCME

Re: Route filters & Patterns

Re: Problem with AAR and site code...