Hi,I have 2 routers.R1 has a Gigabit interface with 2 IP addresses 192.168.100.1 and 192.168.101.1 and a Fastethernet interface with IP address of 192.168.102.4R2 has an Fastethernet interface with IP address of 192.168.102.3 and a serial interface t...

Hi,I want to permit host 10.1.1.1 of network 10.1.1.0/24 on a a 2950 switch and deny all other hosts of this network.Which one is correct?deny ip 10.1.1.0 0.0.0.255 anypermit ip host 10.1.1.1 0.0.0.0 anyorpermit ip host 10.1.1.1 0.0.0.0 anydeny ip 10...

What is the following command good for?switchport mode accessDo I have to execute it on every interface that is member of a vlan to enable filtering through ACL that is applied to vlan?

Hi,This is my switch configuration:Current configuration : 3727 bytes!version 12.1no service padservice timestamps debug uptimeservice timestamps log uptimeservice password-encryption!hostname Switch1!enable secret xxxenable password xxx!ip subnet-ze...

Hi,I want to make a route for traffic destined 196.38.151.0/24 on my router.Configuration of my router (R1) is as followed: F0/0 has IP address 192.168.102.4 G0/1 has IP addresses 192.168.100.1 and 192.168.101.1 Other router (R2) has the following co...