Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Customer hub site has two CE routers with two links connected to two seperate PE routers in the Carrier's MPLS network. At the customer's remote site two CE router with two links are connected to PE router in MPLS network. How can I configure the CE ...
what is the significance of metric when redistributing routes from BGP to ospf.Refer example below :router ospf 100redistribute bgp 65000 metric 65000 subnets tag 65000 route-map BGP-into-OSPFnetwork x.x.x.x area 3Here even if i dont give any metric ...
Hi,I am facing problem with pcanywhere connection through my PIX firewall.I have an access-list which says : access-list permit ip any anythe pcanywhere works fine with this.now In place of "permit IP any any" , i want to allow ports 5631 and 5632 ...
I want to configure Frame-relay over isdn thru dialup. Can anyone guide me on this. the scenario is as given below:i have client at location A. location A is connected to location B on serial port using Lease line. Location B is connected to locatio...
Hi,I have one 128k link thru VSAT(link#1) and one 128k link thru local exchange(link #2). I want to configure load balancing in such a way that1. I want my link#1 to be active only when the traffic on link# 2 reaches 60% of load.2. After the link#2 ...
Thanks for reply Josh.I already have tried an access list allowing tcp port 5631 and udp 5632 but pcanywhere doesnt seem to work. it works fine only with " Permit IP any any " but i dont want to use " permit IP any any "Any other ideas ?Thankskanwal
Hi,Could you expalin the topology of of both of your networks and IP schema used?. In any case the best solution will be redisributing the information between two networks.Thankskanwal
Hi,The acess-list 100 and 101 donot specify any source or destination IP addresses. Could you expalin how the router will identify the Video packets from other packets.Regardskanwal
Hi,The setup is like thisClient H.O--------- POP1------------POP2--------Client B.OPOP1 and POP2 are running FR and are point of presence of an ISP setup.Client will dial thru ISDN from his Head office as well as Branch office and get connected to I...
