Hello smorrissey,May I ask, how many end devices do you have connected to the switch? And if you tried to connect wireless clients simultaneously with wired devices?Because from your config it seems you're using only dynamic NAT:ip nat inside source ...
Hello Nelson,The ACL itself seems to be OK. Could you also provide output from configuration which bonds the ACL to the VTY? (I assume this ACL is supposed to limit remote access to the 2900 router, so remote access is possible only from IPs 10.100.1...
Hello rizwan.So if I got you correctly, in case the both links (via FW and through CPE) are up, you want to load balance the traffic via both paths towards the site B?Because you have mentioned only scenarios when one link fails, not which path shoul...
Hello lolwar,From your setup and description you provided I see some mismatch in IP subneting you calculated.For instance in your diagram you have networks 192.168.0.0/26 (FACULTY), 192.168.0.64/27 (STAFF), 192.168.0.96/29 (point-to-point link betwee...