Hi Ryan,
Thank you for kind response, as per your scenario I hope it is not possible to use the DMZ for the digicoder connection. But please give me some time so that I can try this in the LAB and let me confirm you the status. Thank you for your und...
Hi Suzie,
Thanks for contacting Cisco support community center.
Sorry for the delay in response. I hope your switch management IP should be 192.168.1.254, if so there is nothing to worry about, it is the default status of the switch with system LED ...
Hi
Thanks for contacting Cisco support community center.
Sorry for the delay in response. Sure I will help you on this connection but before we confirm, I need to know few more details from your end so that I can understand your setup better and can ...
Hi,
Thank you for your kind response. Based on your above post I can vie your firmware update from 1.1.0.9 to 1.2.1.7.
Please try to take the router backup and try to downgrade the firmware to 1.1.0.9 and check for the configuration status in this v...
Hi,
I hope you are doing good and sorry for the delay in response, kindly check with the details below.
>>So thats mean that i cant use 1 port (sfp port) to stack and 3 port to connect o another swith, becouse stack
Ans: Sure you can use any 1 comb...