About sunsteel7378

sunsteel7378 · 06-27-2016

This article used a translator. My N7k the bootflash has been corrupted.This has been confirmed as follows.This damage is going to use the recovery tools. (N7000-s2-flash-recovery-tool.10.0.2.tar)But you can not use the NPE.Tell us how -----------In ...

sunsteel7378 · 06-07-2016

I currently use the Nexus N3K.License is in use as described below. show license usageFeature Ins Lic Status Expiry Date Comments C...

sunsteel7378 · 10-14-2015

Good morningI'm using a translator. catalyst 2948g When telnet connection message "No memory for telnet process"The same phenomenon appears in eight devices. Is this a memory bug? * show cdp neighbors detail Port (Our Port): 2/49 Device-ID: JAB04...

sunsteel7378 · 05-26-2015

This question is used a translator.... That caused the problem device "Catalyst 4500 L3 Switch Software (cat4500e-IPBASE-M), Version 12.2(53)SG2topology ----> Backbone switch - L2 switch - AP - deviceUsers use the DHCP.Users found the crash happened,...

sunsteel7378 · 05-04-2015

This question is used a translator.... Current conditions - SW1 ----- Power injector ------ AP(cisco is not another model) - Port, AP, Power injector, Switch <-> Injector UTP cable Problems occur even after replacement - Power injector <->AP UTP ca...

sunsteel7378 · 05-26-2015

The DHCP server is normal....Thank you for your help. :)

sunsteel7378 · 05-26-2015

I think I try to do the protection against attacks.Thank you very much.Your answer was very helpful.Thank you for your kind reply.

sunsteel7378 · 05-26-2015

Sorry .... I'm using a translator.....The wireless Internet users more than 10,000 people.The device is less than 10 may cause problems.The configuration is normal ....889b.39ff.0789 is Samsung mobile phones, this device can only issue ...Thank you f...

sunsteel7378 · 05-26-2015

hi Thank you for your response.889b.39ff.0789 is the DHCP settings..... ;(Virus possibilities Perhaps ??I have seen a similar case.http://itknowledgeexchange.techtarget.com/network-technologies/solution-for-ip-4-dupaddr-duplicate-address-error-log-in...

Member Since	‎04-22-2015 11:53 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	13

User Statistics

User Activity

N7K bootflash raid err, failure to use recovery tool (because NPE Images)

Nexus N3K License OSPF v2 (limited routes)

catalyst 2948g When telnet connection message "No memory for telnet process"

[Unknown Duplicate]%IP-4-DUPADDR: Duplicate address .......

Ask for help :( "%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi1/0/17: Power given, but Power Controller does not report Power Good"

The DHCP server is normal...

I think I try to do the

Sorry .... I'm using a

hi Thank you for your