About daven.delidle

daven.delidle · 01-24-2008

Hi,Trying to route a NM-IDS through a vrf and unnumbered interface. Is this possible? Is there anyone out there doing this? I have attemped this but fails until I nember the interface. Thanks for the help.

daven.delidle · 07-16-2007

Hi,Have a polycom vsx 8000 behind a pix firewall running 7.2 the quality is fine,but after 60 minutes (exactly) the call will drop. We are using dynamic ports on the polycom. Does anyone have an idea on what we can do to extend the call length? Thank...

daven.delidle · 07-11-2007

Hi,Have a IDS Network module set to an unnumbered interface running through a VRF. When I try to initiate a session I get an error "gateway or host down" the loopback that the vrf is linked to is up, the status of the module is ok. I cannot ping the ...

daven.delidle · 06-27-2007

Are IDS 4215 sensors compatable with tacacs? I did not see anything in the csm, the user guides or ids itself that would lead me to believe it was, but just wanted to make sure with the group.Thank you.

daven.delidle · 10-31-2006

Greetings,I'm running ips mc on a windows 2000 server sp 4. when I go to the event viewer section, I'm able to view attacks ok, when I try to delete the events, I click on the delete from database, it warns me, I click ok, all events disapear. I exit...

daven.delidle · 07-19-2007

Hi,I found out the module does not support virtualisation... it's right there in the manual.. when in doubt, read the book I guess is the lesson I have learned.. Thank you for the help. though...

daven.delidle · 07-17-2007

Yep we changed this yesterday (it was the only value set to an hour) and that fixed the problem. Thank you for responding.

daven.delidle · 05-04-2006

Thanks for the reply. They are Cisco 7970 phones, so you are saying that by using the "switchport voice vlan" it automatically "tells" the switch to trunk voice and data seperately? Interesting. Does it work on the 7970?

daven.delidle · 05-03-2006

Greetings Sundar, Thank you for the reply, I'm using a 3550 switch, When I try to enable port security, the command is rejected "you cannot enable port security on a trunk" is the rejection message, but yes, I am trying to enable security on a switch...

Member Since	‎05-31-2005 12:20 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	13

User Statistics

User Activity

NM-IDS through VRF

polycom vsx 800 timeout on pix

NM-CIDS-K9 module with VRF

IDS with tacacs

Not able to delete events permanently from the event viewer

Re: NM-CIDS-K9 module with VRF

Re: polycom vsx 800 timeout on pix

Re: port security on a trunk port 2950

Re: port security on a trunk port 2950