About brendand05

brendand05 · 11-10-2011

Hi I have a 1252 access point and have a questions about the connection speed.I am running off POE which as i understand only has enough power for 1 of the antenna modules.I have disabled the 5GHz module and am running only the 2.4GHz module.When I c...

brendand05 · 10-25-2011

I have a faulty ASA5520 and I am not sure if I have a SMARTnet contract for it or not (I manage over 200+ ASAs)The problem is that the Serial Number sticker that is normally on the back of the ASA is missingThe ASA5520 is also faulty and doesnt power...

brendand05 · 11-23-2010

Anyone been able to get around this?There seems to be a bug with the Office Manager software were it assumes your default gateway is the UC560.It incorrectly picks up the address of your default gateway as the address for the UC560, and so you cannot...

brendand05 · 11-23-2010

I have a client who has ordered a UC560 and 20 x 6921 IP PhonesI am finding conflicting information on the cisco website as to whether these phones are supported or not.The required commands seem to be supported on the UC560, but no phone firmware is...

brendand05 · 10-19-2008

Hi,Am currently running DMS 5.0.5.0.2 has been released October 2008I've looked in all the usual places on CCO but I cannot find any information on what issues this upgrade addresses.Can someone please point me in the direction of the release notes f...

brendand05 · 08-23-2015

"CSCuh94427 - Insufficient Permissions to View BugThis bug contains proprietary information and is not yet publicly available" Large government customer. Hyper-V only.Need to know roadmap for support of ESAV, WSAV, SMAV on Hyper-V

brendand05 · 05-14-2012

Start by finding out what sort of DTMF-relay your SIP provider supports Sent from Cisco Technical Support iPad App

brendand05 · 05-14-2012

5.0 and above will work fine for all the Linux CUCM versions even v8.6For earlier windows based CallManager use the matching number e.g v4.3Sent from Cisco Technical Support iPad App

brendand05 · 05-03-2012

Check your QoS configuration Sent from Cisco Technical Support iPad App

brendand05 · 05-03-2012

You need to hit # (pound/hash) at the end of the code, or wait for the inter-digit timeout to expire (default is 10 seconds)Sent from Cisco Technical Support iPad App

Member Since	‎01-16-2007 06:12 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	86
Total Helpful Votes Received	36

User Statistics

User Activity

Wireless N Speeds?

Serial Number Problem

Office Manager assumes UC560 is the default gateway

Support for 6900 phones on UC560 - Discrepancies

Digital Media System 5.0.2

"CSCuh94427 - Insufficient

Re: calling issue through sip to any company autoattendant

Re: SCCP CCM version command question

Re: h.323 gateway- calls are take a some time to begin

Re: FAC and CMC on CUCM 8.5