About Zigmunds Vitins

Zigmunds Vitins · 07-10-2012

Hello,I would like to find any documentation how to configure IPSEC VPN, but unsuccessfully.At my office are two uplinks - LAN and Backup, both are connected to ASA5510 (with static IP) and I would like to create ipsec to data center where I have ano...

Zigmunds Vitins · 01-02-2012

Hello,I have Cisco WS-C6509 with IOS version 12.2(18)I have several vlan interface on this device.Today I create new vlan intervaceinterface Vlan165 description test5 ip address 10.10.10.1 255.255.255.252endand vlan:VLAN Name ...

Zigmunds Vitins · 12-07-2011

Hi all,I have router cisco 2821 wit IOS version 12.4(25d)I also have Cisco AIM-VPN/SSL-2 Encryption Module for this router.I inserted this module in AIM slot 0 but can not see it.I found in kb: http://www.cisco.com/en/US/docs/ios/12_4t/12_4t11/htvpns...

Zigmunds Vitins · 06-15-2011

Hi all,I have Cisco 6509 with 5 ether-channel configured on it.On one ether-channel other side are Dell Powerconnect 5448 switch.All is working fine for some month, but today for some reasons this Po was disabled (already 4 times).On Cisco in logs I ...

Zigmunds Vitins · 03-02-2011

Hi,I have two blade system's with ESXi hosts on few servers, all ESXi servers are connected to two cisco switch in blade enclosure.Both ESXi adapters are in active mode.All ports on the blade switch are configured as trunk with several vlan id (same ...

Zigmunds Vitins · 07-10-2012

Hello,I found that in Datacenter side in VPN configuration I have to change only one line:crypto map 1 set peer 1.1.1.1 2.2.2.2Is it correct?Thanks.

Zigmunds Vitins · 07-10-2012

Hello,I woud like to use Site to Site ipsec VPNAt this moment I don't have network diagram, but it looks like this: ---primary (ext 1.1.1.1/29) uplink---Office --- interne...

Zigmunds Vitins · 07-10-2012

Yes, that is right, I want if primary uplink in office will fail, ipsec to data center will work through backup link.Thanks

Zigmunds Vitins · 01-03-2012

Hi Vijay,output was: Vlan201 is down, line protocol is down Hardware is EtherSVI, address is 00d0.032a.740a (bia 00d0.032a.740a) Internet address is 12.12.12.1/30after that I executed - "shutdown" and "no shutdown" on vlan interface 201 and all is...

Zigmunds Vitins · 01-03-2012

Hi,this port is up and running:Gi8/14 test6-uplink connected trunk full 1000 1000BaseTThanks

Member Since	‎04-19-2010 05:32 AM
Date Last Visited	‎02-11-2022 12:01 AM
Posts	29

User Statistics

User Activity

VPN configuration on ASA5510 with two WAN

VLAN interface limit

AIM-VPN/SSL-2 installation in Cisco 2821

Etherchannel problems on cisco 6509

STP portfast configuration

Re: VPN configuration on ASA5510 with two WAN

Re: VPN configuration on ASA5510 with two WAN

VPN configuration on ASA5510 with two WAN

VLAN interface limit

VLAN interface limit