Is there some switch configuration that will improve multicast UDP data for a cisco switch?I am working on a program that uses a large amount of multicast traffic as distributed simulation data using a Catalyst 2960G switch.  I have observed sufficie...

Can someone recommend a switch that supports 4096 multicast groups?I am working on a system that includes over a dozen catalyst 2960 switches.  The customer has pointed out the 2960 switch does not satisfy the requirement to support 4096 multicast gr...

I am unable to access a series of switches connected together through a management vlan.  I receive the message "The server xx.xx.xx.xx at level_15_access requires a username and password."  Entering the username and password fails and the same usern...

I am looking for a minimal baseline switch configuration to use setting up a set of switches.The process now is to reset the switch to factory defaults, assign an ip address with switch/telnet password.  Then telnet to the switch and manually enter c...