This command is only for SVI with Nexus - Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide - Configuring Basic Interface Parameters [Cisco Nexus 7000 Series Switches] - Cisco

I agree with Giuseppe EXCEPT for NX-OS - below from the Docs and testing in the lab  Note  If you redistribute static routes, Cisco NX-OS also redistributes the default static route. Cisco Nexus 7000 Series NX-OS Unicast Routing Command Reference - R...

It will negotiate with the peer as to which one to use in numerical/alphabetical order of proposal – not order listing in Policy.  So alphabetically it would be High, Low, Medium - need to see config on other side as well.  

I found another customer with this same issue running 6.2.6 code and nothing worked until we upgraded to 6.2.8a - then all worked as expected.