Hello All,Can anyone explain meaning of the below error message:brse517(config-router-af)#redistribute static route-map SET-COMMUNITY-STATIC% "SET-COMMUNITY-STATIC" used as redistribute static into bgp route-map, set extcommunity rt not supported
What we are doing is that we are using NMHDV2 modules on cisco 2811 chassis but the voice-ports are not showing up for configuration. IOS that we are using is "c2800nm-spservicesk9-mz.124-15.T9"E/M signalling is being used on the voice ports.Please a...
Hello Andrew,What we can do is that we can track the reachability of router A IP address and configure in a way so tht static route will be there only till we have reachability to router A other wise static route will go down and hence will not be re...
Hello,Yes it is possible to do this.what i will suggest is that u can create a trunk between router and the the D-link switch. Please revert for any more clarification. Also put the logs in the next post, if u face any more issues
Hello Giuseppe,Can u please elaborate on below :interesting sh inventory shows no modules are installedNAME: "High Density Voice2 Network module with no board interface on Slot 1", DESCR: >>"High Density Voice2 Network module with no board interface ...
Hello Giuseppe ,Thanks for the update. Can we order these DSP's in separate, or is there anyway we can work out this problem of our's.I am attaching full output of sh diag and sh invntory and sh version command.
Hello,Can u please suggest on below:What we are doing is that we are using NMHDV2 modules on cisco 2811 chassis but the voice-ports are not showing up for configuration. IOS that we are using is"c2800nm-spservicesk9-mz.124-15.T9"E/M signalling is bei...