Hello Cisco Community,I upgraded about 10x A901-6CZ-F-A but got an error on one of the units. Error: Licensing infrastructure is NOT initialized.upgraded to asr901-universalk9-mz.156-2.SP9.bin units boots up fine, but then i get the error and I'm not...
Hello Cisco Experts, I have the following unit: N540-24Z8Q2C-M unit was upgraded from 6.3.3 to 7.4.2the unit boots up for a couple of minutes and then I get the following error and it keeps rebooting in a cycle.FPD was upgraded. Could this be a ...
Hello Cisco Community, I get the following error when I do show license status. Is this normal? perhaps a bug or defective unit? Thanks for your help in advance! Device Credential Verification: FAIL Router# sh license statusLicense Type Supported...
Hello Everyone,
I was not able to find any information regarding both units if they come by default with powers and fans.
Your help is appreciated.
I know this might be a silly question are the powers and fans on the nexus family come by dafult?
...
Hello Cisco Community,
If I have the following part number SRW2008-K9-EU
Can you tell me if we can swap a power cord out of this and make these –NA versions
it looks like the unit uses a power cube adapter?
Your help is much appreciated,
Reg...
Hello Regis Garde,It's been a while but was wondering if you were able to bring up the interfaces up with the command "no shut" or was there anything else that needed to be done. (configuration) would Appreciate a response. Thank you.
Hello Cisco Community,I Have the following unit PN: N540-24Z8Q2C-M V01 with version 7.4.2does not recognize QSFP-100G-LR4-S in HundredGigE0/0/1/1 I get the following error.#LC/0/0/CPU0:2023 Aug 10 22:55:01.959 GMT-6: optics_driver[294]: %PKT_INFRA-FM...
Thank you for your response @Ramblin TechYes, so I was able to format the flash and was able to make room (I used format flash or erase flash) and was able to copy the image,before it was telling I had no space, the upgrade was done from asr901-unive...
shouldn't the unit at least give me the option to go into maintenance mode? Where I can at least run the USB. It's not letting me do it anymore. Thank you for your insight. I think we need to RMA.
I was able to press CRTL + O to boot up from USB.I waited for about 1hr after using the Boot image, and still nothing. The unit keeps rebooting and only sees the message below: Booting CISCO Route Processor Module Thank you for your reply Sam,...
