About gurbinder.kabbay

gurbinder.kabbay · 05-11-2023

Hi ExpertsI am trying to make the double sided vpc as below where N77 pair is fabric path enabled and peer-link is also fabric path enabled. but below 5K switches are not fabric patch enabled and peer-link is also normal trunk link. is it possible to...

gurbinder.kabbay · 04-15-2023

Hi ExpertsI have a very strange experience in which I moved the trunk link from one switch to another and this movement of cable is making SVI down/down.Connectivity like below:Current Connectivity: Switch A<------trunk vlan 100--------->Switch BNew ...

gurbinder.kabbay · 03-14-2023

Hi ExpertsI am doing the base build of switches in stack C9200L048T-4x. SW : 17.06.03.I am configuring the basic ssh to build switches and problem is : when i accessing this switch through other switch locally then login response and running the com...

gurbinder.kabbay · 06-07-2022

Hi All, I have two Edge routers (Primary and secondary) which are connected with AWS and AZURE cloud provider (eBGP connectivity) and respective VRFs (AWS and AZURE) are created on these routers. Problem: When I am doing inter-VRF route leaking betw...

gurbinder.kabbay · 04-29-2022

Hi Experts, I want to know the Clear steps + Exact commands regarding inter VRF communication (for selected subnets only) on Nexus9000 C93180YC-FX.Clear Steps : means I should not miss any steps, so my change should be successful in one Go.Exact comm...

gurbinder.kabbay · 05-15-2023

Hi ExpertsI have fixed this issue, it is very strange issue and it can help someone. so sharing my experience:In current connectivity Trunk was running perfectly fine between Switch A and Switch B. (Both IOS devices).In new Connectivity there was nee...

gurbinder.kabbay · 04-26-2023

I will check the STP mode as you suggested, you mean even port is up between C-->B , the only trunk can go in blocking mode because of STP ?

gurbinder.kabbay · 04-25-2023

Hi ExpertsConnectivity like below:Current Connectivity: Switch A<------trunk vlan 100--------->Switch BNew Connectivity : Switch C<--------Trunk vlan100----------> Switch BSwitch A config: 6509-E, layer 3 SVI created on itint xx/xxswitchportswitchpor...

gurbinder.kabbay · 03-14-2023

Hi ExpertsI have been working on this since morning and did some research and fixed it.@MHM: yes it was both during login and command run.Solution I applied: So routing can be the one of the issues to make it slow. there was default route missed towa...

gurbinder.kabbay · 03-14-2023

thanks for your reply, but cpu utilization is very normalCPU utilization for five seconds: 1Percent/0Percent; one minute: 1Percent; five minutes: 1 Percent

Member Since	‎10-18-2017 05:36 AM
Date Last Visited	‎05-17-2023 12:01 AM
Posts	64
Total Helpful Votes Received	38

User Statistics

User Activity

Double Sided VPC between Fabric path enable and non Fabric switch

SVI is down after moving the trunk link from one switch to another

SSH is working very slow during base build

Inter-VRF route leaking on secondary router is not working

Inter VRF Routing on Nexus devices : Nexus9000 C93180YC-FX

Re: SVI is down after moving the trunk link from one switch to another

Re: SVI is down after moving the trunk link from one switch to another

Re: SVI is down after moving the trunk link from one switch to another

Re: SSH is working very slow during base build

Re: SSH is working very slow during base build