About joselopez

joselopez · 09-29-2016

Hello, Do we have a workaround for this bug ? Do we need to replace the module C6880-X-16P10G? kind regards, José

joselopez · 01-13-2015

Hello, the workaround of the bug isWorkaround:Using recommended QoS configurationsCan we have more explanations about the recommended Qos configuration ?Thanks for you answer,Kind regards,

joselopez · 12-17-2013

Hello,We have a system in VLAN 1, it has IP 146.103.0.113. The catalysts have interface VLAN1 disabled and no ip address assigned. Sometimes, we cannot SSH or telnet from itnetadm towards the catalysts. We can do so from another system called Monalis...

joselopez · 07-12-2012

Hi All,We have a setup with a central router and a remote router. We want to establish 2 PPOE session to the same remote site. We have created 2 dialer interfaces and each interface dialer is attached to 2 different Lan interfaces.We can not establis...

joselopez · 01-03-2006

How to upgrade the software (Ios) in a router with vrfs configuration?

joselopez · 02-28-2020

Hello , In the vlan 125 , the standby group is not the same.in the CAT6509E-VSS: the standby group is 125 and in the CAT6807XL-VSS , the group is 100. Have a nice W-K, José

joselopez · 07-12-2012

Hello adnane,I don't have the config f the server but see below the config of the pppoe client.service timestamps debug datetime localtimeservice timestamps log datetime localtimeservice password-encryption!hostname test!boot-start-markerboot system...

joselopez · 01-03-2006

Hello Martin,I have also try with the command ip tftp source-interface last week but without success.I will try with the workaround that I have proposed and the customer is agree.Thanks very much for your collaboration, it was a pleasure to work with...

joselopez · 01-03-2006

Hi,For snmp, I have a loopback configured in a vrf and then I don't have a problem for management.I can't configured vlan and also I used vrf lite for address-family in BGP It's important to know that in global routing table, I receive any update bec...

joselopez · 01-03-2006

Hi Martin,My problem is that I don't have any entries in the global configuration.In fact, I have 2 separate vrfs routing table and the router use the global routing table to access the tftp server.I have a workaround with a tftp server in the lan an...

Member Since	‎10-20-2004 10:42 PM
Date Last Visited	‎03-01-2024 12:02 AM
Posts	10

User Statistics

User Activity

CSCuv56594

CSCup95827 - ISSU get failed from 6.2.8 to 6.2.10 with 0x40930020

arp entry after copy tftp command

Same PPPOE session ID for different sessions

Upgrade Ios in a vrfs router

Re: How to config HSRP over A-VPLS

Same PPPOE session ID for different sessions

Re: Upgrade Ios in a vrfs router

Re: Upgrade Ios in a vrfs router

Re: Upgrade Ios in a vrfs router